The ƒDDBC100-DALI is now an obsolete product it is recommended to use a DDBC120-DALI instead. 

Supply – 230V 50/60Hz single phase & neutral at 0.1A. ƒ 1 x DALI Output – Suitable for DALI HF ballasts & transformers. ƒ Built-in DALI Bus Power Supply – No external supply required. ƒ Dry Contact Interface – Can be programmed to perform many different functions. The factory settings will cause this input to transmit network identification information. ƒ Many Control Options – Control of this device can be via a combination of methods eg. Serial control port, relay contacts, push button control panels, infrared receivers and timeclocks. ƒ Simple Installation – DIN Rail mount facilitates installat

Special Programming – This device will only operate in basic modes unless programmed via a computer. If programming is required, contact your local agent for details. Once the data cable is connected to the devices, the factory default settings will allow any control panel to control all channels in all dimmers. Check Connections – Tighten all load-carrying screw connections, as vibrations from transport can cause terminal block screws to become loose. Power Sources – This device should only be operated from the type of supply specified on the front cover. This device must be earthed. Load Control Circuit – A 2 core LV control cable is required to be run to the loads, this cable is in addition to the mains feed. Load Type – This product is intended to control DALI devices. Mounting Location – Install in a dry, well-ventilated location. Controllers may emit some mechanical noise. Take this into account when deciding the mounting location. Data Cable – Use screened, stranded RS485 data cable with three twisted pairs. Segregate from mains cable by 300mm minimum. Connect devices in a ‘daisy chain’. A data cable connected to an energized device is live. Do not cut or terminate live data cables.